Author Topic: Metal Machine Putter Grip Questions  (Read 153 times)

titleistgolf_nirvana

Metal Machine Putter Grip Questions
« on: September 20, 2017, 11:12:32 AM »
so I got my hands on one of the aluminum machine putter grips already installed on a shaft....I am wanting to pull the grip and cut the shaft down an inch to my spec and then reinstall it....
just wondering if anyone has any experience with this? does anyone know if they are simply epoxied on the shaft? or is it more complicated than that?
if they are epoxied then it should be an easy experience just don't want to go and do something stupid without inquiring if someone has played with this before
Byron Morgan DH89 Long Plumbers Neck
Machine M10 1st Run Italian Stainless
Machine M10 Carbon Damascus Etch
Machine M10 Proto Art 2 of 2 Mokume Insert

reflog74

Re: Metal Machine Putter Grip Questions
« Reply #1 on: September 20, 2017, 12:57:17 PM »
I would email/PM Dave Billings -- DB MACHINE on PT.

John

LionGolfer

  • Hero Member
  • *****
  • Posts: 806
Re: Metal Machine Putter Grip Questions
« Reply #2 on: September 20, 2017, 10:26:24 PM »
 Not sure but I think they are epoxied so simple heating should do the trick.
BPutters Space
Design Tuning DTP-01
Kitada Slighter Tuned
Machine Big "Balz" Bore, M1A Damascus Ocean Wave "Vivere", M2A Carbon "Casanova"
Nead AS10 Copper
Slighter Seattle
Xenon 84X Stealth, Copper, CuNi Mini, November 15