Recent Posts

Pages: [1] 2 3 ... 10
1
Byron Morgan Putters / Re: 611 refresh
« Last post by bogie on December 11, 2018, 03:09:47 PM »
That came out super nice. Well done!
2
General Putter Talk / Re: Let's See Your Tour Player Putters
« Last post by Oneputt on December 10, 2018, 08:01:11 PM »
Bump - come on guys!! ☺️

Rob

I own no "Tour putters", sorry.
3
The Club House / Memorable Moments of the LPGA 2018 Season
« Last post by tonyj5 on December 10, 2018, 06:56:03 PM »
As we wait for the start of the 2019 season, I would like to look back at what I consider the most memorable moments of 2018:

http://www.tonyslpgareport.com/
4
General Putter Talk / Re: LET'S INCREASE MEMBERSHIP!
« Last post by Rob McHugh on December 10, 2018, 05:20:39 PM »
Bump - let’s all make one of our New Year resolutions to check in frequently and attempt to bring some new blood! 👍👍

Rob

5
General Putter Talk / Re: Let's See Your Tour Player Putters
« Last post by Rob McHugh on December 10, 2018, 05:16:36 PM »
Bump - come on guys!! ☺️

Rob
6
General Putter Talk / Re: Cleaning rust on putter
« Last post by Rob McHugh on December 10, 2018, 05:13:39 PM »
Sorry, just saw this.

I have had some success with a moderate amount of Eezox and 0000 (hobby grade) steel wool.

Good luck 👍

Rob
7
T.P. Mills Putters / Re: Difference between Anvil Trad II xl and 1310 Trad II xl ?
« Last post by Rob McHugh on December 10, 2018, 05:04:52 PM »
If they are both carbon steel with plumbers necks there probably is not much difference except for head weight. XL I believe means the flange is slightly wider. Go with the one that fits your eye!

The 1310 designation is derived from the address of the shop where the concept for the plumbers neck series was born.
Good info here Robb 👍

Rob
8
Wilson Putters / Re: Made in Scotland 8022
« Last post by PSH on December 10, 2018, 02:24:56 PM »
It seems my photos are too large to upload, i have put the putter in Ebay if you can find it.
9
Wilson Putters / Made in Scotland 8022
« Last post by PSH on December 10, 2018, 10:39:48 AM »
Hi All
I picked up a Wilson 8802 , im in the Uk , it has made in Scotland on the handle , with two flags . Will post pictures when i get home , any information on this putter?
10
T.P. Mills Putters / Re: Difference between Anvil Trad II xl and 1310 Trad II xl ?
« Last post by Bonggg on December 10, 2018, 08:36:08 AM »
If they are both carbon steel with plumbers necks there probably is not much difference except for head weight. XL I believe means the flange is slightly wider. Go with the one that fits your eye!

The 1310 designation is derived from the address of the shop where the concept for the plumbers neck series was born.

Thank you
Pages: [1] 2 3 ... 10