Author Topic: LP421- flowneck  (Read 247 times)

KLP1264

LP421- flowneck
« on: August 09, 2017, 05:38:02 PM »
I recently modified one of my early models into a slightly larger mid mallet- something in between the Bayzie and the V201. This one has a small flowneck, but it can also be set up with a single bend shaft or even a small plumbers neck.

303SS with a satin finish- polished bumpers & sole
365g, 68* 3*
Deep milled face
Custom site lines & dot
Cut at 36* and fitted with a SS 2.0 pistol

Kari

bargolf

  • Section Moderator
  • Hero Member
  • *****
  • Posts: 5239
    • barusga
    • BURNT EDGES CONSULTING
Re: LP421- flowneck
« Reply #1 on: August 10, 2017, 06:31:14 PM »
Beauty Kari, Toe Hang?
Byron Morgan Bombora In-Between Long Pipe
Byron Morgan DaKine Long Pipe
Staff Professional Burnt Edges Consulting
SLDR TP 9.5 TP
SLDR 3 14 degree TP
SLDR TP Hybrids 17 and 21
Nike VR Pro Blades 4-9 KBS Tour S
Clay Long Desig TM 50 and 56

KLP1264

Re: LP421- flowneck
« Reply #2 on: August 10, 2017, 07:09:03 PM »
Beauty Kari, Toe Hang?

It was a little bit over 45* Bruce. It had a fairly short flow neck, If I increased the length, I'm sure I could get to 30*

Kari

Pops

Re: LP421- flowneck
« Reply #3 on: August 13, 2017, 10:57:27 PM »
Kari, I love the size and symmetry of this mid mallet head. Extremely interesting. I was wondering how you would make this putter perfectly face balance. Could a double bend shaft be used to get it face balanced? Love the head shape.

Bill

KLP1264

Re: LP421- flowneck
« Reply #4 on: August 14, 2017, 01:43:05 AM »
Kari, I love the size and symmetry of this mid mallet head. Extremely interesting. I was wondering how you would make this putter perfectly face balance. Could a double bend shaft be used to get it face balanced? Love the head shape.

Bill

Yes Bill- a double bend shaft would work and get it face balanced.

Kari

Pops

Re: LP421- flowneck
« Reply #5 on: August 14, 2017, 07:24:58 AM »
Kari, I love the size and symmetry of this mid mallet head. Extremely interesting. I was wondering how you would make this putter perfectly face balance. Could a double bend shaft be used to get it face balanced? Love the head shape.

Bill

Yes Bill- a double bend shaft would work and get it face balanced.

Kari

Thanks Kari,

I was wondering which mid mallet head would be approximately the same size as the older Cameron Fastback No. 1 ?

Bill